BannerFans.com
Showing posts with label jet ski. Show all posts
Showing posts with label jet ski. Show all posts

Monday, July 9, 2012

Jet Ski Not Starting?

Older Model Bombardier Seadoo Jetski will not start.
It feels like it will start but actually not getting started.

WHAT CAN CAUSE THIS?

There are many basic possibilities that can cause this.
If its sitting for long time before getting started then may be internal electric parts are got dirty and needs to be inspected and serviced if required.

First of all check the fuel in the system.If its low on gas then get it refilled and see if that is helping.

Other possibility is low battery charge.Get the battery tested and inspected.If volt is low then recharge the battery.If the battery terminals are dirty,then disconnect battery wires and clean them with contact cleaner,also clean the area where battery terminals are fitted and then see if that is helping.

BATTERY IS RECHARGED AND FUEL IS FULL?

If still the same problem is noticed then start with the basics, remove the plugs and inspect them, if they are black and sooty then its problem.The plugs will need to be replaced, 2 stroke engine require frequent plug replacement. If they look good inspect them for spark.
To check for spark, remove the plug and reconnect the wire to it, lay it on the cylinder head and look for a bright blue spark. It sounds to me like you likely only have a set of fouled plugs.
If spark is less and low then replace the plugs.First try cleaning the plugs and see if that makes any difference.If not then plugs are faulty and needs replacing.

ANY OTHER POSSIBILITY IF SPARK PLUGS CHECKED OK?

Yes,if plugs checked ok then It is possible that debris have come loose from the inside of the fuel tank and have now plugged up the carbs, at that point the carbs will need to come off and be serviced. To service the carbs the carbs needs to be completely disassembled and cleaned.
If you are not able to do this servicing,then get the carbs serviced at proper garage shop by professional mechanic.

This details will help.
Thank.

MORE RELATED SOLUTIONS BELOW:---


Yamaha Waverunner has Starting issues


Crank Seals Blown on Yamaha Waveraider

How to remove Flywheel on Jet ski?

Jetski Sputters and Low RPM?



Jetski Sputters and Low RPM?

2002 Honda ARX1200 Aquatrax Jet Ski Sputters and Gives Low RPM


It Starts and runs fine,but in minutes it will sputter and needs to be stopped.

WHAT IS THE CAUSE OF THIS PROBLEM?

One common problem noticed on this model Honda jet-ski is dirty connectors.
In the front of the engine under where the seat clips you will find 2 large multi wire plugs, inspect both of these plugs for corrosion and make sure when the connectors are plugged in that the wires do in fact insert into the other connector and are not pushed out the back of the plug. Those connectors are a common problem with that ski.In most of such cases the connectors are the issue.Disconnecting the wires from this connectors,cleaning the wire terminals and connectors with proper contact cleaner,then reinserting the wires properly to there respective connectors helps/

IF THAT IS NOT THE CASE THEN?

Then in most of such cases you get FI/light buzzer warning indication.
This indicates that there error codes stored in the system.
You will have to retrieve the error codes.Those error codes will tell you whats the issue is.

To retrieve error codes manually try this simple procedure ,jump the service check connector to get the stored codes.

This details will help.
Thanks.

Related help solution:----

How to remove Flywheel on Jet ski?

http://www.howtorepairguide.com/2012/07/how-to-remove-flywheel-on-jet-ski.html